×

Call Us: 866-4-LAZERS (SALES)
Support: 951-496-3710

Mercury III

Drivers

Mercury III Firmware Complete version 1.06-01. Extract to C Drive, and it will make a folder called LaserPro. Instructions and all required will be in the folder.
Download

Mercury III Firmware 3_05_03 for New (Red Color) Main Boards only. If your MB is Green use the other Firmware File.
Download

Mercury III Print Driver v4.07-03 for all versions of Windows. With Mercury III on and connected to PC, double click .exe file for automatic installation. See instructions below “Instructions on how to install and configure your LaserPro Print driver for” USB or Ethernet.
Download

Instructions

Manual Focus Tool Chart
Download

Mercury X and Y Flag CorelDRAW File
Download

Mercury X Flag Photo
Download

Beam Alignment instructions
Download

How to manually fire the laser for a Laser Power Meter Test
Download

Adjusting Laser Tickle Pulse. This will need to be done if at the extreme beginning, and end of the raster passes, a single pixel is visible on your material. This effect is most noticeable on Gold and Black engraving plastic.
Download

How to install the old (non .exe versions) of the Print Driver on a 32 or 64 Bit OS PC via USB
Download

How to set Origin with the Red Beam as a reference
Download

How to set Origin with Calipers. Only use Red Beam method if you do not have calipers for precision measurement.
Download

Mercury III User Manual. Do not operate machine without reading complete manual.
Download

How to Upgrade the Firmware. These instruction will also be in the firmware download once unzipped.
Download

LaserPro DirectPrint MAC AI Plug-In User Manual CSX
Download

Instructions on how to install and configure your LaserPro Print driver, and USB port connection.
Download

Instructions on how to install and configure your LaserPro Print driver when connected via Ethernet port connection.
Download

Movies

Instructions for proper cleaning of the Mirrors and Lenses. Remember there are 4 mirrors, at least 1 Focus lens, and an optic on the end of the actual laser. The red beam mirror requires no special attention and is not counted as one of the above 4 mirrors. The mirrors are gold plated silicone and should be treated very carefully to avoid damage. The only way to damage a laser optic is by not cleaning when dirty, or by cleaning improperly.
Download

How to use the Rotary Attachment using Center Home. Part 1 the Software setup portion.
Download

How to use the Rotary Attachment using Center Home. Part 2 the Hardware setup portion. Your model may be different then shown, but the instructions are the same for all models.
Download

How to release, and seat the X Motor Cable Connection for X PCB and Main Board.
Download