×

Call Us: 866-4-LAZERS (SALES)
Support: 951-496-3710

Spirit

Drivers

Firmware 3.02-06 Complete with instructions and utility. Unzip to your C Drive. It will create a folder called LaserPro.
Download

Spirit Print Driver v4.04-03 for all versions of Windows. See Instructions below on installation and configuration of the driver.
Download

Instructions

Manual Focus Tool Chart
Download

Proper Location of Lens in the Lens Carriage
Download

How to set Origin on a Spirit Series with Calipers
Download

How to Upgrade the Firmware on the Spirit
Download

Manual Focus Tool Chart
Download

Proper Location of Lens for C180 and Spirit Series Lens Carriages
Download

SmartGUARD Fire Alarm Device_SI SG SGX
Download

Beam Alignment instructions
Download

How to manually fire the laser for a Laser Power Meter Test
Download

Spirit User Manual
Download

Tuning Auto Focus for the Spirit Series
Download

Adjusting Laser Tickle Pulse. This will need to be done if at the extreme beginning, and end of the raster passes, a single pixel is visible on your material. This effect is most noticeable on Gold and Black engraving plastic.
Download

How to install the old (non .exe versions) of the Print Driver on a 32 or 64 Bit OS PC via USB
Download

How to set Origin with the Red Beam as a reference
Download

How to set Origin with Calipers. Only use Red Beam method if you do not have calipers for precision measurement.
Download

How to Upgrade the Firmware. These instruction will also be in the firmware download once unzipped.
Download

LaserPro DirectPrint MAC AI Plug-In User Manual CSX
Download

Spirit X Flag CorelDRAW file. Cut out new flag using 1/16″ Engraving Plastic, preferably with a black core (for visual reasons only). If your flag is broken turn machine on with lens carriage pushed to far right side of machine.
Download

Photo of the X Flag. If yours had been broken off, download the CDR file to create a new one. The flag file varies by model. Please insure you download the flag file from the correct machine page in support.
Download

Spirit Series user Manual for Spirit, Spirit LS, Spirit GLS and Spirit GLS Hybrid.
Download

Instructions on how to install and configure your LaserPro Print driver, and USB port connection.
Download

Spirit Series User Manual (V15) Do not operate machine without reading complete manual.
Download

Movies

This video should be watched if you are printing from an application, and the file never makes it to the Spooler or the Laser.
Download

Instructions for proper cleaning of the Mirrors and Lenses. Remember there are 4 mirrors, at least 1 Focus lens, and an optic on the end of the actual laser. The red beam mirror requires no special attention and is not counted as one of the above 4 mirrors. The mirrors are gold plated silicone and should be treated very carefully to avoid damage. The only way to damage a laser optic is by not cleaning when dirty, or by cleaning improperly.
Download

How to use the Rotary Attachment using Center Home. Part 1 the Software setup portion.
Download

How to use the Rotary Attachment using Center Home. Part 2 the Hardware setup portion. Your model may be different then shown, but the instructions are the same for all models.
Download

How to release, and seat the X Motor Cable Connection for X PCB and Main Board.
Download

Power Settings

Power and Speed Starting Point for various materials for all models and wattage’s.
Download